| Model |
IW9167EH-B-STA2 |
| Software |
● Cisco IOS XE Software Release 17.15.2 or later |
| Supported wireless LAN controllers |
● Cisco Catalyst 9800 Series Wireless Controllers (physical or virtual) |
| 802.11n version 2.0 (and related) capabilities |
● 4x4 MIMO with four spatial streams in one 2.4 GHz radio and two 5 GHz radios |
| ● Maximal Ratio Combining (MRC) |
| ● 802.11n and 802.11a/g |
| ● 20- and 40-MHz channels |
| ● PHY data rates up to 1.5 Gbps (with 40 MHz on both 5 GHz radios and 20 MHz on the 2.4 GHz radio) |
| ● Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive) |
| ● 802.11 Dynamic Frequency Selection (DFS) |
| ● Cyclic Shift Diversity (CSD) support |
| 802.11ac |
● 4x4 downlink MU-MIMO with four spatial streams on both 5 GHz radios |
| ● Maximal Ratio Combining (MRC) |
| ● 802.11ac beamforming |
| ● 20, 40, and 80 MHz channels |
| ● PHY data rates up to 3.4 Gbps (dual 4x4:4SS 80 MHz) |
| ● Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) |
| ● 802.11 DFS |
| ● CSD support |
| ● Wi-Fi Protected Access (WPA) 3 support |
| 802.11ax |
● 4x4 uplink/downlink MU-MIMO with four spatial streams in 2.4, 5, and 6 GHz* |
| ● Uplink/downlink OFDMA |
| ● Target Wake Time (TWT) |
| ● BSS coloring |
| ● Maximal Ratio Combining (MRC) |
| ● 802.11ax beamforming |
| ● 20, 40, 80, and 160 MHz channels (IW9167E 5/6 GHz radio, IW9167I, IW9167E-STA and IW9167E-STA2 6 GHz radio) |
| ● 20, 40, 80 channels (5 GHz radio) |
| ● 20 MHz channels (2.4 GHz radio) |
| ● PHY data rates up to 7.8 Gbps (4x4 160 MHz on 6 GHz, 4x4 80 MHz on 5 GHz, and 4x4 20 MHz on 2.4 GHz) |
| ● Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) |
| ● 802.11 DFS |
| ● CSD support |
| ● WPA3 support |
| Antennas |
● 2.4 GHz and BLE: Peak gain 7 dBi, ±45° crosspolarized, directional antennas |
| ● 5 GHz: Peak gain 13 dBi, ±45° cross-polarized, directional antennas |
| ● 6 GHz: Peak gain 13 dBi, ±45° cross-polarized, directional antennas |
| ● GNSS: Average gain -2 dBi, linearly polarized, omnidirectional antenna |
| Interfaces |
● 1x 100M/1000M/2.5G/5G Multigigabit Ethernet (RJ-45)/M12 X-code autosensing PoE+ in (802.3at/bt), UPOE in |
| ● 1x SFP (copper) 100M/1000M/10G Multigigabit Ethernet /M12 X-code OR 1x SFP (fiber) 1G/10G |
| ● Management console port (RJ-45) |
| ● Multicolor system LED |
| ● DC power input (micro-fit/M12 A-code) |
| ● Reset button |
| Note: PG 13.5 glands or M12 adapters shall be used with Ethernet and power interfaces to meet IP67 rating. |
| Note: Catalyst IW9167E-HZ has permanent M25 ports. M12 adapters are not compatible. See Installation Guide for gland requirements. |
| Dimensions (W x L x H) |
● 14.5 x 14.5 x 4.3 in (36.8 x 36.8 x 10.9 cm) |
| Weight |
● 15.5 lb. (7 kg) |
| Input power requirements |
● 802.3at (PoE+), 802.3bt (PoE++), Cisco Universal PoE (Cisco UPOE®) |
| ● DC power source: 24 to 48 VDC (maximum voltage range: 18 to 60 VDC) |
| ● Cisco power AC-DC power adapter, IW-PWRADPT-MFIT4P= |
| ● Cisco power injector, IW-PWRINJ-60RGDMG= |
| Surge |
● DC power input |
| ◦ EN50121-4, ± 2 kV (line-earth) and ± 1 kV (line-line) |
| ◦ AREMA, ± 1 kV (line-earth) and ± 1 kV (line-line) |
| ◦ CISPR35, ± 0.5 kV (line-earth) |
| ● Surge protection to ± 2 kV on Ethernet ports |
| ● Surge protection to ± 1 kV on SFP copper port with shielded cable |
| Environmental |
● Nonoperating (storage) temperature: -40° to +185°F (-40° to +85°C) |
| ● Nonoperating (storage) altitude test: +25˚C (77˚F), 17,000 ft. |
| ● Operating temperature: -40° to +158°F (-40° to +70°C) with solar load and still air. |
| ● Extended operating temperature (DC powered, not applicable to IW9167ESTA and IW9167E STA2): -58° to +167°F (-50° to +75°C) without solar loading, still air, and cold start limited to-40°C |
| ● Operating type test: +85°C for 16 hours |
| ● Operating humidity: 0% to 100% (condensing) |
| ● Operating altitude: 15,000 ft. (4,500 m) |
| ● Wind resistance: Up to 160 mph (257 km/h) sustained winds |
| Environmental ratings |
● EN/IEC 60529 (IP66 and IP67) |
| System memory |
● 2048 MB DRAM |
| ● 1024 MB flash |
| Available conducted transmit power settings (max/min), all antennas active |
2.4 GHz |
5 GHz |
5/6 GHz |
| ● 24 dBm (250 mW) |
● 30 dBm (1 W) |
● 23 dBm (200 mW) |
| ● -4 dBm (0.4 mW) |
● -4 dBm (0.4 mW) |
● -4 dBm (0.4 mW) |
Cisco Catalyst IW9167EH-B-STA2 có ưu điểm gì về hệ thống ăng-ten so với phiên bản IW9167EH-B-STA?
Cisco Catalyst IW9167EH-B-STA2 được trang bị ăng-ten định hướng tích hợp có độ lợi cao hơn, đạt 13 dBi trên cả băng tần 5 GHz và 6 GHz, trong khi phiên bản IW9167EH-B-STA chỉ đạt 9 dBi và 10 dBi tương ứng. Độ lợi ăng-ten cao giúp tăng khoảng cách truyền tín hiệu, cải thiện chất lượng liên kết không dây và giảm suy hao trên các kết nối đường dài, đặc biệt phù hợp cho các ứng dụng cầu nối không dây giữa các tòa nhà hoặc khu công nghiệp.
Cisco Catalyst IW9167EH-B-STA2 phù hợp với những mô hình kết nối mạng nào?
Cisco Catalyst IW9167EH-B-STA2 được thiết kế tối ưu cho các mô hình Point-to-Point (PtP) và Point-to-Multipoint (PtMP), nơi cần truyền dữ liệu tốc độ cao giữa các địa điểm cách xa nhau mà không cần triển khai cáp vật lý. Với tốc độ PHY lên đến 7,8 Gbps và ăng-ten định hướng công suất cao, thiết bị đáp ứng tốt các hệ thống giám sát, nhà máy thông minh, cảng biển và hạ tầng giao thông.
Cisco Catalyst IW9167EH-B-STA2 mang lại lợi ích gì khi triển khai trong các dự án mạng không dây ngoài trời quy mô lớn?
Cisco Catalyst IW9167EH-B-STA2 kết hợp chuẩn Wi-Fi 6/6E, ăng-ten định hướng độ lợi cao, giao diện Multigigabit Ethernet và SFP 10 Gbps, cùng khả năng hoạt động ổn định trong điều kiện môi trường khắc nghiệt đạt chuẩn IP66/IP67. Những đặc điểm này giúp thiết bị duy trì kết nối ổn định trên khoảng cách xa, giảm chi phí triển khai hạ tầng có dây và nâng cao tính sẵn sàng của mạng trong các dự án công nghiệp, năng lượng và giao thông thông minh.